Address:No.500 Qianhu Road, Huishan District, Wuxi City
Tel:0086-13771176471
Email:
manager18@wxweihua.com.cn
Weihua has developed more than twenty series of roll forming steel production line from initial single layer roof roll foaming machine, can meet all kinds of steel construction need of architecture.
Deck Roll Forming Machine technical parameter
1) Manual decoiler: passive uncoiling, manual expanding
2) Weight capacity of decoiler: 15T
3) Machine stand adopts welded steel structure with shot blasting treatment.
4) Motor power of main forming machine:18.5KW×2 (380V/60Hz /3 phase)
5) Motor of hydraulic station:3KW
6) Hydraulic oil pump:gear pump CB-E314
7) Roller station:33 stations
8) Forming speed:10m/min
9) Material of roller: 45# forged steel (with heat treatment)
10) Surface of roller coated with chrome of 0.05mm thickness.
11) Type of main forming machine:single station with chain for transmission
12) Specification of single station: WHPF40
13) Leader: ¢40
14) Diameter of bearing assembly hole: ¢60
15) Diameter of roller shaft: ¢85
16) Chain: 20A
17) Cutting:hydraulic cutting
18) Material of cutting blade:Cr12, hardness is HRC60°-62°
19) Thickness of material:0.8-1.2mm
20) Feeding width: 1200mm
21) Tolerance of cutting length:10m±2mm
22) Locating of movable station:fixed by square key and screw
23) Bearing of fixed station:taper bearing installed in pairs
24) Type of feeder:side wheel type
25) Transducer:Hongquan
26) Computer adopts PLC, OMRON
27) Working pressure of hydraulic system:12Mpa
28) Computer operating board adopts Thinget OP320A
29) Output table: roller type without power
Deck Roll Forming Machine flow chart
PROFILE
Deck Roll Forming Machine application